Bueno ya que me puse a ver en una parte del foro, que estaban preguntando porque el Vtec Light no lo tiene algunos carros y otro si.
bueno para el que quiera hacerlo esto corre bajo su cuenta y precaucion. no me hago responsable de esto.
primero lo pongo en ingles para aquellos que sepan ingles les es mas facil
1.) Take out your cluster and remove the plastic covering. If you can't come this far without directions, please don't try this.
2.) There is the open space where i put the vtec light in the cluster.
3.) Turn that over and you'll see a small plastic type covering. Somepeople cut that part out and put in a folder tab. with this used a cd case and print the letters VTEC.
for the first 3 points here is the pic for that
4.) Now, put the cluster back in and route the wires to the ECU. Open the cover and locate the GREEN wire with YELLOW stripe. This is the VTEC wire. WARNING: There is also a YELLOW wire with GREEN stripe. This is the Fuel pump wire. When you have found the VTEC wire, use a wire tap and connect the wire from the ecu to the LED.
5.) Now look up and you'll notice this screw. It is what holds the glove box up. Use this as your ground. There are many other places you can use, but i decided to use this one.
6.) Hide all of the wires and put everything back together and take it out for a test drive. If you have done it correctly, it should light up when you hit 5500 rpm.
bueno para el que quiera hacerlo esto corre bajo su cuenta y precaucion. no me hago responsable de esto.
primero lo pongo en ingles para aquellos que sepan ingles les es mas facil
1.) Take out your cluster and remove the plastic covering. If you can't come this far without directions, please don't try this.
2.) There is the open space where i put the vtec light in the cluster.
3.) Turn that over and you'll see a small plastic type covering. Somepeople cut that part out and put in a folder tab. with this used a cd case and print the letters VTEC.
for the first 3 points here is the pic for that
4.) Now, put the cluster back in and route the wires to the ECU. Open the cover and locate the GREEN wire with YELLOW stripe. This is the VTEC wire. WARNING: There is also a YELLOW wire with GREEN stripe. This is the Fuel pump wire. When you have found the VTEC wire, use a wire tap and connect the wire from the ecu to the LED.
5.) Now look up and you'll notice this screw. It is what holds the glove box up. Use this as your ground. There are many other places you can use, but i decided to use this one.
6.) Hide all of the wires and put everything back together and take it out for a test drive. If you have done it correctly, it should light up when you hit 5500 rpm.
Archivos adjuntos
Última edición: